Glide for VT14

by Joe Bristor Tue Sep 24, 2013 8:31 am

I have a new glide design I need tested.

It fits the VT14.
It's a recessed slot/hybrid design, and it's a new material.
I'll won't cost you a dime, just need your input.
Any Takers?
Ummm I mean Givers?
Call me if interested.

Joe
253 653-7209

by Davey Cracker Tue Sep 24, 2013 4:24 pm

Love to try it, but I think my wand is 13" Sad

by Ryan S Tue Sep 24, 2013 4:45 pm

Joe if you haven't sent the red release you can add it to my shipment. It should fit my WP 14 right?

by ( miller ) gerry Wed Sep 25, 2013 5:29 am

Joe, I would like to try it. I have been meaning to ask you. I have the hybrid on my VT14. Can I modify it with a dremmel tool or anything else? I always pre-vac, but sometimes it does not pick up larger loose pieces left on carpet like the slotted glides I have always used. Thanks. Gerry

by William Simpson Wed Sep 25, 2013 6:05 am

Joe would love to try it, either on the wp14, aw29, or the 13 in evolution wand- which one would you like

by Ryan S Wed Sep 25, 2013 6:19 am

( miller ) gerry wrote:Joe, I would like to try it. I have been meaning to ask you. I have the hybrid on my VT14. Can I modify it with a dremmel tool or anything else? I always pre-vac, but sometimes it does not pick up larger loose pieces left on carpet like the slotted glides I have always used. Thanks. Gerry

Gerry,

I order the super holes glide from joe and use a drill press to make it a hybrid. I turn ever other hole into a slot.

by Ryan S Sat Oct 26, 2013 8:42 am

Any guys who have these glides have a report on performance?

by Joe Bristor Mon Oct 28, 2013 6:03 pm

Sorry, I just now saw the responses to this.
Ended up sending all 3 samples I had to a gn RC up in Cansada who I trust.
It was a big flop.
He hated them. They fit good but they're not Teflon, rather a polymer, harder han Teflon but don't slide as easily. he gave it 5 minutes then went back to Teflon.
So ya';'ll didn't miss nuthin..

Gerry, I could send you a different pattern if you want. NC.
Not sure if you should try to pull off what Ryan does.
He's master machinst certified ya know.

Btw, I don't feel too bad, cuz I did say...
"Call me if interested.

Joe
253 653-7209"

by Ryan S Mon Oct 28, 2013 6:17 pm

Haha your right Joe. We all failed reading comprehension. laughing

by Sponsored content

Glide for VT14

Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14

Re: Glide for VT14